NOTICE - Dallas Area Classic Chevys Message Board Will Soon Be Deactivated

Believe me when I say that the pleasure was George's and mine. What better way to spend a beautiful fall day than with friends who enjoy driving our beloved cars. And as luck would have it, mother nat ...

Next Saturday (10/14) we will depart from the Lowes parking lot at Highway 287 and Debbie Lane in Mansfield for a short cruise (about 50 miles) to the Motorsports Ranch and lunch at the BBQ on the Bra ...

K&N Engineering (Filters) is having a Cars and Coffee show and Open House at their plant in Grand Prairie on June 10th starting at 8:00 a.m. until ?.
The address is 741 Refuge Way, just west of t ...

I'm looking for someone or some shop who has had experience trouble shooting the Fitech fuel injection system.
Please answer here if you know anybody.

Thanks.
Marvin Cowden

***It's gone***

David Hudson has a free motor out of a 1988 Chevy pickup.
It's a four-bolt main, one piece rear main seal, flat tappet cam but machined for GM roller cam. The heads are stock TBI u ...

So, I ran out of gas the other day. My wife loves it when I do that.
The gauge showed I still had 1/4 tank left.
It used to be dead on accurate so what changed?
I pulled the tank and peered inside ...

We are in the middle of a revolution regarding the automobile and power generation in general.
It was bound to happen and it will be a sad time for us car guys but for the sake of the planet it must ...

*SOLD*

1947 Chevy P/U, professionally built with 56 Desoto 330 ci dynoed at 300 hp. Desoto Avenger 2x4. Mild cam.
Built by a speed shop in California.
Muncy 4 speed, new clutch pack (less than ...

I know of someone who is wanting to buy a classic, nice reliable driver. If you have one or know of one, please contact me here.

Marvin Cowden

The club has a set of body lifts and a rotisserie so if you wheeled the car outside, removed the body to frame bolts, you could then lift the body off, and bolt it to the rotisserie and do the job rig ...

Those who didn't get to attend this cruise missed a chance to drive on the most scenic roads in Texas.
The clouds parted and the tree lined lanes made the reason we own these autos perfectly clear.
...

Rick, call me -

The latest addition of Hot Rod magazine has a very good article on converting a car to hydra-boost. You might want to check it out.

I'm not positive but you might be able use hydra-boost without po ...

CPP sells an entire package for your car.
Check out the website below for their offerings.

www.classicperform.com/Store2/Hydraulic-Brake-Assist-Systems.htm

This system has saved my car several ...

I'm partial to the hydra-boost setup if you are serious about stopping. Seems a lot of people are using them, especially if you have an aftermarket cam that drops your vacuum level below what a v-boos ...