Jemo 210 Series
Joined: 12 Jan 2006 Posts: 40 Location: Double Oak
|
Posted: Thu Jul 05, 2007 7:32 pm Post subject: Sheetmetal for sale - floors, fender, and psgr rocker panel |
|
|
I started buying sheetmetal before I knew what I had and ended up just buying complete floor sections so I have the following stuff for sale. The parts have been sitting unused for over a year so they're starting to get very light surface rust on them but should be very easy to clean up. They're all brand new, never used:
$50 each: LH and RH front floor pans, similar to this:
http://www.danchuk.com/12_01_front_floor_pans.html
$65 each: LH and RH rear floor pans, similar to this:
http://www.danchuk.com/12_01_rear_floor_pans.html
$70 - Drivers side rear, under seat pan, similar to this:
http://www.danchuk.com/12_01_seat_re...pans.html#2339
I have a set of used inner fenders for a '56. They're used but in good condition. I'll take $175 obo for those.
I have a passenger front fender. The headlight bucket part is solid. The lower portion is rusted but I have the patch piece for it. $250 obo including the patch piece (not welded).
Last, I started taking my rocker panels off today and went to look at the replacement rockers that I bought a year ago. The unknown vendor gave me TWO passenger side rocker panels. If you need a outer rocker panel for the passenger side, I'll take $70.
Thanks,
Jeff |
|