| View previous topic :: View next topic |
| Author |
Message |
2NDTIMEAROUND
Bel Air
Joined: 12 Feb 2007
Posts: 71
Location: Mesquite, Tx.
|
 Posted: Mon Aug 29, 2011 9:32 pm Post subject: Trunk Seal |
 |
|
The gasket seal I got from Danchuk seams to be too hard (dense) and will not allow the trunk lid to close flush, It's raised about 1/4" along the sides and the back. Has anyone else experienced this? Any suggestions on getting the seal from another vendor?
Thanks. 
_________________
"Getting older is inevitable......acting your age is a choice....I choose not to! |
|
| Back to top |
|
 |
acardon
Bel Air
Joined: 12 Jul 2005
Posts: 273
Location: Southlake, Tx.
|
| Posted: Tue Aug 30, 2011 7:21 pm Post subject: |
|
|
I just installed a T & N Rubber trunk seal on my 57 and it went on and closes pretty good. At first, it was a little harder to close, but after about a week, it's closeing much easier.
T & N Rubber
phone: 704-788-1418. |
|
| Back to top |
|
|
2NDTIMEAROUND
Bel Air
Joined: 12 Feb 2007
Posts: 71
Location: Mesquite, Tx.
|
| Posted: Wed Aug 31, 2011 8:47 pm Post subject: |
|
|
Thanks for the info. I'll give them a call.
_________________
"Getting older is inevitable......acting your age is a choice....I choose not to! |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
