View previous topic :: View next topic |
Author |
Message |
55 Hardtop
Joined: 08 Feb 2017 Posts: 2 Location: Frisco
|
Posted: Thu Feb 09, 2017 5:00 pm Post subject: Metal Body Work |
|
|
Hi All,
I am new to Dallas Area Classic Chevy. I just picked up a 1955 Chevy 2 door Hardtop Bel Air. The rear quarter panel was cut out due to it being hit at some point. It needs a ton of patching of metal panels, i.e. floor boards, trunk floor, maybe rockers, and who know what after sand blasting.
I am looking for a trusted place for sand blasting and metal work. I just don't want to get ripped off by metal guys who charge more hours than they actually worked. I am willing to take it anywhere in Dallas/Fort Worth area that will do a great job.
I have contacted North Texas Customs and he seems good over the phone and on his website but would like a trusted recommendation.
Thank you all for any advice and I will be utilizing you all for more questions as the build progresses. Thanks. |
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
David Graves Site Admin
![](http://www.dallasclassicchevy.com/images/00%20Misc%20personal/dag%20avatar.jpg)
Joined: 02 Jun 2005 Posts: 1384 Location: Warsaw, TX
|
Posted: Thu Feb 09, 2017 10:03 pm Post subject: |
|
|
Welcome!
You might check North Texas Rod & Custom near Kaufman. Jack Ellison is a club member and he would do you right.
http://www.ntrci.com _________________ In My Garage -
'55 Bel Air Hardtop
'55 Bel Air 2dr Sedan
'56 Corvette
'67 Camaro RS
'69 Blown 427 nostalgia front engine dragster
'17 Indian Chief Vintage |
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
55 Hardtop
Joined: 08 Feb 2017 Posts: 2 Location: Frisco
|
Posted: Fri Feb 10, 2017 8:47 pm Post subject: |
|
|
Thanks for the response. I will give them a look.
Does anyone have any experience with North Texas Customs in Wylie? |
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
|